10l 8.0Mpa Liquid Nitrogen Generator 95% PSA N2 Generator

10 Liters Liquid Nitrogen Generator LN2 Production Machine Psa Nitrogen Generator

Description

As a concise nitrogen production process, PSA can generate a lot of nitrogen within a few minutes after the PSA nitrogen generator is turned on, and the energy consumption is low, resulting in a much lower cost than cryogenic air separation nitrogen production and liquid nitrogen on the market. . In the whole operation process, anyone can control the content displayed by the imported microcomputer, without special training for the operator. Although the whole process is fully automatic operation, the operator only needs to press the start switch, but the function is very stable. , then the automatic job

Parameter

Correct use

1. The PSA nitrogen generator needs to turn off all power switches, including the nitrogen generator, nitrogen inlet valve and sampling valve, and wait for the system and pipeline to be completely depressurized. Adjust the oxygen analyzer for sampling and adjust the pressure of the pressure reducing valve to 1.0bar, adjust the sampling flowmeter, and adjust the gas volume to about 1. Note that the sampling gas volume should not be too large, and begin to test the nitrogen purity.

2. Only after the compressed air pressure reaches 0.7mpa or more, the shut-off valve of the nitrogen generator can be opened. At the same time, it is necessary to observe the pressure change of the adsorption tank and whether the pneumatic valve can work normally.

3. The pressure of the regeneration tower is zero, and the pressure of the two towers should be close to half of the pressure of the original working tower.

4. Close the entire system and all parts of the system. When the pressure of the adsorption tank of the nitrogen generator reaches about 0.6MPa, observe whether the nitrogen generator system is working normally.